All About Epoxy Garage Ground Coating Methods

Why have an epoxy garage ground? Normal garage floors are just basic grey concrete. Over time, stains from grease, oils, and chemicals lead to basic grey concrete to become an hideous eyesore. Possessing an epoxy garage floor coating will give you years of services, durability and will resist most stains as nicely as provide you with a superbly, completed surface to preserve the value of your residence.

The Most Typical Epoxy Ground Coating Systems

There are a few frequent systems obtainable that will enhance your garage flooring:

1. Epoxy & Polyurethane Strong Color Program

2. Epoxy Chipstone (partial vinyl chip broadcast) with Polyurethane Prime Coat Technique

3. Epoxy Granitex (a hundred% vinyl chip broadcast) with Polyurethane Best Coat Technique

Keep in head that with these 3 epoxy techniques, you have ‘good’, ‘better’ and ‘best’ sorts of epoxy garage flooring methods.

The Excellent Program

The epoxy polyurethane solid color technique will last about five-7 years, servicing cost-free, but will call for a routine maintenance coat of pigmented polyurethane. This garage floor coating is normally a two-coat, thin movie program ranging in thickness from 4-twenty mils. It is applied by roller or airless sprayer.

The Better Method

The epoxy Chipstone program will final about 7-12 a long time, servicing totally free before needing a maintenance coat of very clear polyurethane. This epoxy garage flooring method generally consists of one pigmented primer coat of epoxy a pigmented coloration coat with a partial/gentle broadcast of vinyl chips into the wet epoxy and a single coat of very clear polyurethane for protection. The thickness is around 20-thirty mils.

The Ideal Method

The epoxy Granitex technique can very last as prolonged as 12-fifteen+ many years, maintenance free of charge before needing a routine maintenance coat of polyurethane. This epoxy floor coating is typically a single pigmented primer coat a pigmented coloration coat with a a hundred%/total broadcast of vinyl chips and two coats of distinct polyurethane.


Correct area planning is important to the lengthy expression success of the set up. All surfaces to be coated must be cleaned of contaminants which may possibly interfere with bonding. Concrete need to be acid-etched, shot-blasted or diamond-ground to obtain a profile related to one hundred twenty grit sandpaper. Right after preparation, the concrete surface should be inspected for holes and cracks. If holes or cracks are common, then patchwork must be executed. After preparing is full, installation is prepared to commence.

Set up of epoxy garage floor kansas city :

1. Surface preparation, patchwork and roll one particular coat of pigmented epoxy primer.

two. Following epoxy primer is dry, inspect, prep and roll 1 coat of pigmented epoxy more than primed location. Perform in 10×10 or 12×12 sections at a time. While epoxy is moist, broadcast vinyl chips into moist epoxy. Be confident the region receives one hundred% coverage. When all sections are completely coated, allow dry extensively.

three. As soon as all sections are dry, scrape, sweep and vacuum all surplus Granitex vinyl chips from the surface area. Use a thin coat of polyurethane to lock and lay vinyl chips down.

four. When the polyurethane is dry, implement a second coat for a final best coat. As an alternative, non-skid resin sand can be extra to improve the slip resistance.

All epoxy garage floor coatings can be very easily cleaned with mild, liquid detergents then mopping, hosing or even “swiffering”. Grease, oils, and most substances will not stain or absorb into the epoxy coated floor.

Leave a Reply

Your email address will not be published.